目前，傳統的汽油機仍有其獨到的優勢。研究人員可通過采用較高的壓力來改善汽油機的燃油經濟性和排放，而針對點火系統的改進主要通過減小火花塞尺寸來實現。

At present, the traditional gasoline engine still has its unique advantages. Researchers can improve the fuel economy and emission of gasoline engine by using higher pressure, while the improvement of ignition system is mainly realized by reducing the size of spark plug.

對于傳統汽油機而言，預燃室具有更高的技術潛力，其目前已應用于1級方程式賽車（Formula 1）等車型中。預燃室是在汽油機燃燒室內部的1個小型燃燒室，可通過安裝1個傳統火花塞而實現。預燃室可通過小孔連接主燃燒室，可燃混合氣則在進氣行程中進入預燃室，并由火花塞點燃?；旌蠚恻c燃后形成的火焰鋒面從預燃室表面的小孔流出，并點燃主燃室中的可燃混合氣。燃燒室內的多個點火位置可使混合氣更快且更充分地進行燃燒。研究人員可對汽油機的運行特性圖進行調整，以改善燃油經濟性和功率。

For traditional gasoline engines, the precombustion chamber has higher technical potential, which has been applied to models such as Formula 1. The precombustion chamber is a small combustion chamber inside the combustion chamber of gasoline engine, which can be realized by installing a traditional spark plug. The precombustion chamber can be connected to the main combustion chamber through a small hole, and the combustible mixture enters the precombustion chamber during the intake stroke and is ignited by the spark plug. The flame front formed after the mixture is ignited flows out of the small hole on the surface of the precombustion chamber and ignites the combustible mixture in the main combustion chamber. Multiple ignition positions in the combustion chamber enable the mixture to burn faster and more fully. Researchers can adjust the operating characteristic diagram of gasoline engine to improve fuel economy and power.

2種布置型式

2 layout types

預燃室通常有2種設計型式。主動型是在預燃室中采用1個額外的燃油或燃?xì)鈬娚淦?，從而對可燃混合氣進行調節與控制。被動型則通過預燃室與主燃室之間的壓力差來實現氣體交換。

There are usually two design types of precombustion chamber. The active type uses an additional fuel or gas injector in the precombustion chamber to regulate and control the combustible mixture. The passive type realizes gas exchange through the pressure difference between the precombustion chamber and the main combustion chamber.

從20世紀60年代末開始，針對預燃室點火過程已開展了一系列優化，但研究人員則將更多精力集中于改善燃油經濟性和排放過程，并通過調整試驗程序以分析更寬工況范圍內的發動機運轉特性。到目前為止，汽油機預燃室技術已取得了一系列進展。

Since the late 1960s, a series of optimization has been carried out for the ignition process of the precombustion chamber, but researchers have focused more on improving fuel economy and emission process, and analyzed the engine operating characteristics in a wider range of operating conditions by adjusting the test program. So far, a series of progress has been made in the technology of gasoline engine precombustion chamber.

MJI技術可使汽油機在λ=2的條件下同樣實現理想的燃燒效果，同時也改善了燃油經濟性和排放過程。但當λ值越接近2，可燃混合氣被點燃的難度也會相應更高。

Mji technology enables gasoline engines to λ= 2, while improving fuel economy and emission process. But when λ The closer the value is to 2, the more difficult it is for the combustible mixture to be ignited.

技術應用

Technology application

研究人員針對預燃室技術提供了相應的優化方案。在主動型MJI系統中，可通過噴油器以提高預燃室中的可燃混合氣濃度，點火后形成的熱自由基（hot radicals）在傳入主燃燒室后會形成多個著火點，從而可在λ=2的稀薄混合氣中產生強烈的燃燒過程。

Researchers provide corresponding optimization schemes for precombustion chamber technology. In the active Mji system, the fuel injector can be used to increase the concentration of combustible mixture in the precombustion chamber. The hot radicals formed after ignition will form multiple ignition points after being introduced into the main combustion chamber λ= A strong combustion process occurs in the lean mixture of 2.

該系統可有效減少平均有效燃油耗（BSFC）約15%或更多，但技術挑戰也悄然而至。預燃室專用的噴油器需要進行專門開發，并與后處理系統相匹配。因此，研究人員目前正在對被動型MJI系統進行開發。但在該系統中，主燃燒室中的可燃混合氣會受到廢氣再循環（EGR）系統的影響，從而減小了其著火范圍。

The system can effectively reduce the average effective fuel consumption (BSFC) by about 15% or more, but the technical challenge also comes quietly. The special fuel injector for the precombustion chamber needs to be specially developed and matched with the aftertreatment system. Therefore, researchers are currently developing a passive Mji system. However, in this system, the combustible mixture in the main combustion chamber will be affected by the exhaust gas recirculation (EGR) system, which reduces its ignition range.

在理論空燃比下進行的點火能減少燃燒過程的持續時間，由此能相應提高EGR率。而通過EGR也能相應優化汽油機的抗爆燃性，使整機壓縮比可相應增大，同時BSFC也減少了約10%。

The ignition under the theoretical air-fuel ratio can reduce the duration of the combustion process, so as to improve the EGR rate accordingly. The anti deflagration performance of gasoline engine can also be optimized by EGR, so that the compression ratio of the whole engine can be increased, and the BSFC can be reduced by about 10%.